CoCo-80 User Manual
111
Figure 125. Accept/Reject display for transient capture.
The frame average number is displayed in the status bar to help you monitor how
many averages have been recorded. When the averaging mode is set to linear and
you reached the averaging number you are prompted to restart a new test by
pressing the Run Button.
When the averaging mode is set to exponential then new frames will be acquired
and included in the average until you press the Hold Button. The system does not
stop when the average number reaches the averaging number. The averaging
number only defines the behavior of the averaging function. Exponential
averaging is intended for continuous averaging to help observe how a signal
changes over time or converges to a mean.
Figure 126. When averaging is complete you can restart a new test with
the Run Button.
To Next Page
Loading...