CoCo-80 User Manual
33
are defined in the CSA as display candidates will be visible and available to be
added to the trace. This feature is designed to simplify the user interface and
optimize the CoCo-80 computation resources. If a signal is not available for
display then the CSA must be edited before it can be added.
After the first signal is selected, only signals of the same type will show in the list.
Additional signals of the same type can be selected to overlay them on a single
trace.
To set up a window with two traces, first select Add a Window with two
Traces. The following screen will be displayed:
Figure 33. Edit window screen is used to add/delete window and add
signals to each trace.
In this screen the top and bottom trace can be defined by selecting appropriate
signals in the same way as you set up the one trace window. To switch between
top and bottom traces within the window, press Shift.
View Mode changes the mode of the current display. The signals can be
displayed in a graphic plot or as a text value. The text value can display different
quantities such as RMS, Peak, and Average value of the signal. For graphic plots,
the view mode also selects the ordinate scale type (linear, logarithmic, or dB).
Depending on the type of plot (time stream, APS, etc), different selections will be
available. The view mode can also be changed in the Display window, by pressing
the F1 (Traces) soft button and selecting Select View Mode for Current
Trace.
To Next Page
Loading...
