CoCo-80 User Manual
34
Figure 34 In screen of Trace and Windows Setting different view modes
can be selected
Other soft buttons under the Trace and Window settings control the windows in
the current display. Add Window creates a new window in the Window List.
Windows are named sequentially as Window1, Window2, etc. Delete Window
removed the highlighted window from the Window List. Clear Signals removes
all signals from the highlighted trace. Select All Signals adds all signals to the
highlighted trace. Cancel returns to the previous screen without changing the
trace definitions. OK saves the changes to the trace definitions and returns to the
previous screen.
Param (F2)
Param opens the Parameter Settings Menu. This menu sets parameters for the
sampling rate, input and output channels, triggering, spectral saving, and time
stream recording.
Figure 35. Parameter Settings menu.
Param -> Sampling Rate (fs)/Freq. Range(fa) is used to set the sampling
rate or frequency range for data acquisition. Sampling rate and frequency are
related, the frequency range is approximately 45% of the sampling rate. Use the
Up and Down arrow buttons to select from the scroll menu and press Enter to
accept the setting. Frequency range is a global setting that applies any loaded
CSA.
To Next Page
Loading...
