CoCo-80 User Manual
35
Param -> Analysis Parameters is used to change parameters that are defined
in the CSA project. These parameters depend on the definition of the CSA project
but may include block size/line, window type, average mode, average number,
weighting type, etc. Refer to the CSA project description in Section 4 for more
details. Analysis Parameters are dependent on the selected CSA. Different set of
CSAs may show different Analysis Parameters.
Figure 36. Analysis Parameters Setup Screen for A CSA Project.
Param -> Input Channels brings up the Sensor and Channel Setting
window. It displays the peak magnitude of each channel over a small averaging
time period. The vertical scaling of the bars is logarithmic, which helps the user
see both large and small signals.
Thanks to the high-dynamic technology implemented in the CoCo, as long as the
signals are within the full range, the measurement will be accurate. However if the
signals are above the full range, overload will occur and the instrument will flash
to warn the user.
To Next Page
Loading...
