CoCo-80 User Manual
60
Figure 81: Main System Setup Page
Figure 82: Calibration Start Page
F1 (View Report) – view the calibration report.
F2 (Meter Info) – edit meter parameters (Operator, Meter Model, Meter
Series, and Description)
F5 (Cancel) – go back to previous screen without saving any changes.
F6 (Next) – go to the next step.
The CoCo will follow 10 steps to complete a self calibration.
1. Introduction
2. Calibrate the output offset (10 V Range)
To Next Page
Loading...
