EasyManua.ls Logo

Cupra Ateca 2020 - Fog Lights; Turn Signal and Main Beam Lever

Cupra Ateca 2020
352 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
Never drive with daytime lights if the road
is not well lit due to weather or lighting
conditions.
On vehicles with rear lights with bulbs,
when activating the daytime running light
the rear lights are not switched on. A vehi-
cle which does not have the rear lights on
may not be visible to other drivers in the
darkness, in the case of heavy rain or in
conditions of poor visibility.
WARNING
If the headlights are set too high and not
used correctly, there is a risk of dazzling or
distracting other road users. This could re-
sult in a serious accident.
Always make sure that the headlights are
correctly adjusted.
Note
The legal requirements regarding the use
of vehicle lights in each country must be
observed.
The dipped beam headlights will only
work with the ignition on. The side lights
come on automatically when the ignition is
turned off.
The rear fog light can dazzle drivers be-
hind you. You should use the rear fog light
only when visibility is very poor.
Fog lights
Fig. 93
Dash panel: lights control.
The warning lamps
or
also show, on the
light switch or instrument panel, when the
front fog lights are on.
Turning on the front fog lights*
: pull
the light switch out to its first click position
Fig. 93
1
, from positions
,
or

.
Turning on the rear fog light
: pull the
light switch fully out
2
from position
,
or

.
To switch off the fog lights, press the light
switch or turn it to position
.
Note
The rear fog light can dazzle drivers behind
you. You should use the rear fog light only
when visibility is very poor.
Turn signal and main beam lever
Fig. 94
Turn signal and main beam lever.
More the lever to the required position:
Right turn light or right-hand parking
light (ignition switched off).
Left turn light or left-hand parking light
(ignition switched off).
Turning main beam headlights on: con-
trol lamp
lit up on the instrument pan-
el.
The headlight flasher comes on while we
pull the lever. Control lamp
lit up.
Place the lever in rest position to turn off the
corresponding function.
1
2
3
4
114

Table of Contents

Related product manuals