Information for the user
●
Plastic parts and elastomers are marked in
accordance with ISO 1043, ISO 11469 and
ISO 1629.
Choice of materials
●
Use of recycled materials.
●
Use of compatible plastics in the same part
if its components are not easily separated.
●
Use of recycled materials and/or materials
originating from renewable sources.
●
Reduction of volatile components, includ-
ing odour, in plastic materials.
●
Use of CFC-free coolants.
Ban on heavy metals, with the exceptions
dictated by law (Annex II of ELV Directive
2000/53/EC): cadmium, lead, mercury,
hexavalent chromium.
Manufacturing methods
●
Reduction of the quantity of thinner in the
protective wax for cavities.
●
Use of plastic film as protection during ve-
hicle transport.
●
Use of solvent-free adhesives.
●
Use of CFC-free coolants in cooling sys-
tems.
●
Recycling and energy recovery from resi-
dues (RDF).
●
Improvement in the quality of waste water.
●
Use of systems for the recovery of residual
heat (thermal recovery, enthalpy wheels,
etc.).
●
The use of water-soluble paints.
Recycling of electrical or electronic
devices
All electrical or electronic devices (EED) that
are not permanently fitted in the vehicle
must be marked with the following symbol:
This symbol indicates that EED must not be
discarded as home waste but through selec-
tive waste collection.
Information about the EU Di-
rective 2014/53/EU
Simplified EU compliance declaration
Your vehicle has different radioelectrical de-
vices. The manufacturers of these devices
declare that they comply with Directive
2014/53/EU when legally required.
The full text of the EU compliance declara-
tion is available online at the following ad-
dress:
www.cupraofficial.com
Addresses of the manufacturers
According to the Directive 2014/53/EU, all
relevant components must include the ad-
dress of the manufacturer.
The address of the manufacturers of com-
ponents that, due to their size or nature,
cannot include a sticker are listed below, as
long as it is legally required:
Radioelectrical
equipment fitted in
the vehicle
Addresses of the
manufacturers
Radiofrequency remote
control key
Della KGaA Hueck & Co.
Rixbecker Straße 75
59552 Lippstadt, GERMANY
Radio frequency remote
control (auxiliary heat-
er)
Digades GmbH
Äußere Weberstraße 20
02763 Zittau, GERMANY
Transmitted-Receiver
(independent heating)
Radar sensors for assis-
tance systems
ADC Automotive Distance
Control Systems GmbH
Peter-Dornier-Straße 10
88131 Lindau, GERMANY
Robert Bosch GmbH
Postfach 16 61
71226 Leonberg, GERMANY
324
To Next Page
Loading...
