EasyManua.ls Logo

Cupra Ateca 2020 - Using the Instrument Panel; Operation Using the Multifunction Steering Wheel; Changing Menu Settings

Cupra Ateca 2020
352 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
Using the instrument panel
Introduction
With the ignition switched on, it is possible to
read the different functions of the display by
scrolling through the menus.
The multifunction display can only be con-
trolled from the buttons on the multi-func-
tion steering wheel.
Some menu options can only be read when
the vehicle is at a standstill.
WARNING
Distracting the driver in any way can lead to
an accident and cause injuries.
Never use the menus on the instrument
panel display while the vehicle is in motion.
Note
After loading or changing the 12-volt bat-
tery, check the system settings. If the pow-
er supply is interrupted, the system settings
might be incorrect or deleted.
Operation using the multifunction
steering wheel
Fig. 62
Right side of the multifunction steering
wheel: buttons to the menus and information dis-
plays on the instrument panel.
As long as a priority 1
page 72 warning is
active, it will not be possible to access any
menu. Some warnings can be confirmed and
hidden with the button

of the multifunc-
tion steering wheel
Fig. 62 .
Select a menu or an informative display
Switch the ignition on.
If a message or vehicle symbol is displayed,
press the button

Fig. 62 ; if necessary,
several times.
To change menus, use buttons
or
Fig. 62.
To open the menu or the information dis-
played, press the button

Fig. 62 or wait
a few seconds until the menu or the informa-
tive display opens automatically.
Changing menu settings
In the menu displayed, turn the right
thumbwheel of the multifunction steering
wheel
Fig. 62 until the desired option of
the menu is highlighted. The option appears
framed.
Press the button

Fig. 62 to make the
required modifications. A mark indicates that
the system or function is activated.
Back to menu selection
Press the button
or
.
Note
If when switching on the ignition warnings
are shown about existing faults, it might not
be possible to change the settings or show
the information as described. In this case,
go to a specialised workshop and request a
repair.
80

Table of Contents

Related product manuals