Cupra Ateca 2020 - Parking and Manoeuvring with Reverse Assist

Driving
Infotainment system screen. Part of the
bumper can be seen at the bottom, which
can be used by the driver as a reference
point.
Rear assist settings
Rear assist offers the user the possibility to
change the image's brightness, contrast and
colour settings.
To change these settings:
●
Stop the vehicle in a safe place without
switching off the ignition or the infotainment
system.
●
Apply the parking brake.
●
Select reverse gear.
●
Press the

function button displayed on
the screen.
●
Make the desired adjustments on the
menu by pressing the
–
/
+
function buttons
or by moving the scroll button.
Requirements for parking and manoeu-
vring with the rear assist
The system should not be used in the follow-
ing cases:
●
If the image displayed is not very reliable or
is distorted, or if the lens is dirty.
●
If the area behind the vehicle is incom-
plete.
●
If the vehicle is heavily loaded.
●
If the position of the camera has changed
after a rear-end collision. Have the system
checked by a specialised workshop.
Familiarising yourself with the system
To familiarise yourself with the system, the
orientation lines and their function, CUPRA
recommends practising in a place without
too much traffic or in a car park when there
are good weather and visibility conditions.
Parking and manoeuvring with re-
verse assist
Fig. 193
On the Infotainment system screen.:
guide lines.
Meaning of the orientation lines
›››
Fig. 193
Lateral lines: extension of the vehicle
(approximately in its total width) on the
road.
1
End of the side lines: approx. 2 m be-
hind the vehicle on the road.
Intermediate line: approx. 1 m behind
the vehicle on the road.
Horizontal red line: a safe distance of
approx. 40 cm at the rear of the vehicle
on the road.
Switching the system on and off
●
Reverse assist is connected by a contact
when engaging reverse gear.
●
The system switches off 8 seconds after
disengaging reverse gear and immediately
after removing the contact.
●
The camera will stop transmitting images
above the speed of 15 km/h (9 mph) with re-
verse engaged.
In combination with the parking aid plus sys-
tem
›››
page 260 , the camera image will no
longer be displayed when reverse gear is dis-
engaged, and the system will display the op-
tical information provided by the parking aid
system.
It is also possible to hide the reverse assist
image:
●
By pressing one of the Infotainment system
buttons on the display.
●
OR: by clicking on the miniature vehicle
shown on the screen.
2
3
4
272