EasyManua.ls Logo

Cupra Ateca 2020 - Fitting a Child Seat Using the Seat Belt

Cupra Ateca 2020
352 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Transporting children safely
Weight group
Front passenger seat
a)
Rear side seat Rear central seat
b)
Airbag activated airbag disabled
c)
Group 0 to 10 kg X U U U
Group 0+ to 13 kg X U U U
Group I 9 to 18 kg X U U U
Group II 15 to 25 kg X UF UF UF
Group III 22 to 36 kg X UF UF UF
X: Not compatible for the installation of seats install chairs in this configuration.
U: Suitable for universal restraint systems for use in this weight group.
UF: Acceptable for front-facing universal-category child restraint systems approved for this mass group.
a)
Compliance with current national legislation and the manufacturer's instructions is required when using or installing child seats.
b)
For semi-universal chairs where the securing system is the car safety belt and the support bracket, do not use them in the centre rear seat.
c)
Seats without height adjustment should be placed in their rearmost position. Seats with height adjustment should be placed in their rearmost and highest position.
Fitting a child seat using the seat belt
Set the height of the seat belt such that it
adapts to the child seat naturally, without
twisting. The lowest position of the seat belt
height regulator must be used with rear-fac-
ing child seats.
Put the seat belt in place and pass it
through the child seat according to the in-
structions of the child seat manufacturer.
Make sure that the seat belt is not twisted.
Insert the latch plate into the seat's buckle
until you hear the engagement click.
WARNING
When travelling, children must be secured
in the vehicle with a restraint system suita-
ble for age, weight and size.
Read and always observe information and
warnings concerning the use of child seats
page 32.
39

Table of Contents

Related product manuals