Operation
WARNING
Even when the outside temperature is
higher than freezing temperature, some
roads and bridges could be frozen.
●
The “ice crystal symbol” indicates that
there may be a risk of freezing.
●
At outside temperatures above +4 °C
(+39 °F), there may be ice even when the
“ice crystal symbol” is not on.
●
The outside temperature sensor takes a
guideline measurement.
Note
●
There are different instrument panels
and therefore the versions and instructions
on the display may vary. In the case of dis-
plays without warning or information texts,
faults are indicated exclusively by the con-
trol warning lamps.
●
Some indications on the instrument pan-
el screen may be concealed by a sudden
event, e.g. an incoming call.
●
Depending on the equipment, some set-
tings and instructions can be carried out or
displayed on the infotainment system as
well.
●
If there are several warnings at the same
time, the symbols will be displayed one af-
ter the other for a few seconds. The sym-
bols will stay on until you remove the cause.
●
If when switching on the ignition warn-
ings are shown about existing faults, it
might not be possible to change the set-
tings or show the information as described.
In this case, go to a specialised workshop
and request a repair.
Instrument panel menus
The number of menus and information items
available will depend on the vehicle’s elec-
tronics and features.
A specialised workshop can programme or
modify additional functions, according to
the vehicle equipment. To do so, CUPRA
recommends going to a specialised CUPRA
dealer or any SEAT dealership.
Some menu options can only be read when
the vehicle is stationary.
■
Driving data
›››
page 71
■
Assist systems.
■
Front Assist On/Off
›››
page 224
■
ACC (only display)
›››
page 228
■
Lane Assist On/Off
›››
page 233
■
Travel Assist On/Off
›››
page 235
■
Side Assist On/Off
›››
page 239
■
Navigation.
■
Audio.
■
Telephone.
■
Vehicle status
›››
page 72
Service Menu
In the Service menu various settings can be
adjusted depending on the features.
Open the Service menu
To open up the
Service
menu, select the
Range
information profile while in the
Driv-
ing data
menu, and keep the key press-
ed on the multifunction steering wheel for
approximately 4 seconds. When it is re-
leased, the
Service
menu will be displayed.
Now you can browse through the menu us-
ing the keys on the multifunction steering
wheel as usual.
Restart the service interval display
Select the
Service
menu and follow the in-
structions on the screen of the instrument
panel.
Restart the oil service
Select the
Restore Oil service
menu and
follow the instructions on the instrument
panel display.
Restart journey data
Select the
Reset trip
menu and follow the
instructions on the instrument panel display
to reset the value.
70
To Next Page
Loading...
