EasyManua.ls Logo

Cupra Ateca 2020 - Automatic Ignition Disconnection; Driving; Starting and Stopping the Engine; Switching the Ignition On;Off

Cupra Ateca 2020
352 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Driving
Driving
Start and driving
Starting and stopping the en-
gine
Ignition and start button
Fig. 139
Starter button
The engine can be started with a start button
(Press & Drive). To do so, there must be a val-
id key inside the vehicle in the area of the
front or rear seats, or on the centre console.
The



button is found at the bot-
tom of the centre console or, depending on
the version, on the multi-function steering
wheel.
In vehicles with the Keyless Access
›››
page 92system, the engine can also be
started with the key in the luggage compart-
ment.
Opening the driver's door when exiting the
vehicle activates the electronic lock on the
steering column if the ignition is disabled.
Switching the ignition on/off
If you only want to switch on the ignition
(without starting the engine), briefly press
the start button once without pressing the
brake pedal or the clutch pedal
›››
.
The



push-button text flashes
like a heartbeat when the system is ready for
the ignition to be turned on or off
1)
.
Automatic ignition disconnection
If the driver leaves the vehicle, taking the key
with them but leaving the ignition on, the ig-
nition does not switch off automatically. The
ignition is switched off by pressing the lock
button on the remote control
or by press-
ing the sensor surface on the door lever
›››
Fig. 77.
Automatic deactivation of the ignition on
vehicles with the Start-Stop system
The ignition is switched off automatically
when the vehicle is stopped and the auto-
matic engine shutdown is active, if:
●
The driver's seat belt is not fastened,
●
the driver does not step on any pedal,
●
the driver door is opened.
After automatically turning off the ignition, if
the dipped beam
is on, the side light re-
mains on for approx. 30 minutes (if there is
enough charge in the battery). If the driver
locks the vehicle or manually turns off the
light, the side light goes out.
Engine restart feature
If no key is detected inside the vehicle after
the engine stops, you will only have 5 sec-
onds to restart it. A warning will display on
the dash panel screen.
After this interval, it will not be possible to
start the engine without a valid key inside the
vehicle.
1)
Valid for versions with the start button on the
centre console.
196

Table of Contents