Seats and headrests
●
Press and hold the button
›››
Fig. 106 .
●
Within the following 10 seconds, push the
open button
on the vehicle key. An audi-
ble warning confirms the settings have been
deactivated.
Initialising the seat position memory
The position memory system must be restar-
ted if, for example, the driver seat has been
changed.
Restarting deletes all memories and assign-
ments for the seat with position memory.
The memory buttons can then be reprog-
rammed and the vehicle keys re-assigned.
●
Open the driver door and do not get into
the vehicle.
●
Operating the seat settings from outside
the vehicle.
●
Move the angle of the seat backrest com-
pletely forwards.
●
Release the control to set the angle and
then press again until an audible warning is
heard.
WARNING
Adjust the memory function only when the
vehicle is stationary.
Note
If the driver door is opened approx. 10 mi-
nutes after the vehicle was unlocked or lat-
er, the driver seat and the exterior mirrors
do not move automatically.
Folding down and raising the rear seat
backrest
Fig. 107
Rear seat: folding the backrest.
Fig. 108
In the luggage compartment: levers for
remote release* of the left part
1
and right part
2
of the rear seat backrest.
The rear seat backrest is split and each part
can be lowered forward separately to extend
the luggage compartment.
Lowering the rear seat backrest with the
unlock button
●
Push the headrest down as far as it will go
›››
page 126.
●
Pull the unlock button
›››
Fig. 107
1
for-
ward and lift the backrest at the same time.
The rear seat backrest is not engaged when
the red marking of the button
2
is visible.
Folding down the backrest from the boot
with the unlocking levers*
●
Push the headrest down as far as it will go
›››
page 126.
●
Open the rear lid
›››
page 103 .
»
129
To Next Page
