Cupra Ateca 2020 - Additional Brake Light; Changing the Number Plate Bulbs; Side Turn Signals

Emergencies
Changing the number plate bulbs
Fig. 53
In the rear bumper: Number plate light.
Fig. 54
number plate light: remove the bulb hold-
er.
Follow the steps indicated:
–
Press the number plate light in the direc-
tion of the arrow
›››
Fig. 53 .
–
Detach the number plate light.
–
Turn the connector lock
›››
Fig. 54 in the
direction of arrow
1
and pull on the con-
nector.
–
Rotate the bulb holder in the direction of
the arrow
›››
Fig. 54
2
and extract it to-
gether with the bulb.
–
Replace the faulty bulb with a new identical
bulb.
–
Insert the bulb holder into the number
plate light and rotate all the way in the op-
posite direction to the arrow
›››
Fig. 54
2
.
–
Plug the connector into the bulb holder.
–
Insert the number plate light carefully into
the opening on the bumper. Ensure that
the number plate light is in the correct po-
sition.
–
Insert the number plate light into the
bumper until it audibly clicks into place.
Note
Depending on how equipped the vehicle is,
the number plate lights may be LEDs. LEDs
have an estimated life that exceeds than
that of the car. If a light with LEDs fails, go
to an authorised workshop for replace-
ment.
Side turn signals
Fig. 55
Turn signal integrated in the rear view mir-
ror
The side turn signals are LEDS and are inte-
grated in the exterior mirrors.
In case of failure, go to an authorised work-
shop to have them replaced.
Additional brake light
Taking into account that it consists of LED
bulbs, the change should be made at a tech-
nical service centre.
62