EasyManua.ls Logo

Cupra Ateca 2020 - Cleaning Windscreen Wiper Blades; Changing the Wiper Rear Wiper Blades

Cupra Ateca 2020
352 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Self-help
Changing the wiper rear wiper blades
Fig. 38
Changing the windscreen wiper blades
Fig. 39
Changing the rear wiper blade
The windscreen wiper blades are supplied as
standard with a layer of graphite. This layer is
responsible for ensuring that the wipe is si-
lent. If the graphite layer is damaged, the
noise of the water as it is wiped across the
windscreen will be louder.
Check the condition of the wiper blades reg-
ularly. If the wipers scrape across the glass,
they should be changed if they are damaged,
or cleaned if they are dirty
›››
.
If this does not produce the desired results,
the setting angle of the windscreen wiper
arms might be incorrect. They should be
checked by a specialised workshop and cor-
rected if necessary.
Damaged windscreen wiper blades should
be replaced immediately. These are available
from qualified workshops.
Raising and lowering windscreen wiper
arms
●
Place the windscreen wipers in the service
position
›››
page 48 .
●
Grip the wiper arms only by the blade's fas-
tening point.
Cleaning windscreen wiper blades
●
Raise the wiper arms.
●
Use a soft cloth to remove dust and dirt
from the windscreen wiper blades.
●
If the blades are very dirty, a sponge or
damp cloth may be used
›››
.
Changing the windscreen wiper blades
●
Lift and unfold the wiper arms.
●
Press and hold release button
›››
Fig. 38
1
and pull gently on the wiper blade in the di-
rection of the arrow.
●
Fit a new wiper blade of the same length
and design on to the wiper arm and hook it
into place.
●
Rest the wiper arms back onto the wind-
screen.
Changing the rear window wiper blade
●
Lift and fold the wiper arm.
●
Turn the blade slightly
›››
Fig. 39 (arrow
A
).
●
Hold down the release button
1
while
gently pulling the blade in the direction of ar-
row
B
.
●
Insert a new blade of the same length and
type in the rear wiper arm in the opposite di-
rection to the arrow
B
and hook into place
button
1
.
●
Replace the wiper arm on the rear window.
WARNING
Worn or dirty windscreen wiper blades re-
duce visibility and increase the risk of acci-
dent and serious injury.
●
Always replace damaged or worn wind-
screen wiper blades or blades that no lon-
ger clean the windscreen properly.
»
49

Table of Contents