Operation
The following features are then available
without having to use the vehicle key active-
ly:
●
Keyless Entry: unlocking the vehicle using
the handles of the front doors or the soft-
touch/handle on the rear lid.
●
Keyless Exit: locking the vehicle using the
sensor of the driver or passenger door han-
dle.
●
Easy Open: opening the rear lid moving
one foot below the rear bumper
›››
page 105.
●
Press & Drive: keyless starting of the engine
with the starter button
›››
page 196 .
The central locking and locking systems op-
erate in the same way as a normal locking
and unlocking system. Only the controls
change.
Unlocking the vehicle is confirmed with a
double flash of the indicator lights; locking
by a single flash.
If the vehicle is locked and then all doors and
the rear lid are closed leaving the last key
used inside the vehicle and none outside,
the vehicle will not lock immediately. All the
vehicle's indicator lights will flash four times.
The vehicle will lock after a few seconds if
you do not open any door or the rear lid.
The vehicle will lock again after a few sec-
onds if you unlock the vehicle but fail to
open any door or boot hatch.
Unlocking and opening the doors
(Keyless-Entry)
●
Grip one of the front door handles. When
you do this, you touch the sensor surface
›››
Fig. 77
A
(arrow) of the handle and the
vehicle unlocks.
●
Open the door.
On vehicles with selective opening or info-
tainment system configuration, pulling the
door handle twice will unlock all doors.
In vehicles without the “Safe” security sys-
tem: closing and locking the doors
(Keyless-Exit)
●
Switch the ignition off.
●
Close the driver's door.
●
Touch (once) the locking sensor surface
›››
Fig. 77
B
(arrow) on one of the front door
handles. The door that is used must be
closed.
In vehicles with the “Safe” security system:
closing and locking the doors (Keyless-
Exit)
●
Switch the ignition off.
●
Close the driver's door.
●
Touch (once) the sensor surface
›››
Fig. 77
B
(arrow) on one of the front door handles.
The vehicle locks with the “Safe” security
system
›››
page 98 . The door that is used
must be closed.
●
Touch (twice) the sensor surface
›››
Fig. 77
B
(arrow) of one of the front door handles
to lock the vehicle without activating the
“Safelock” security system
›››
page 98 .
Unlocking and locking the boot hatch
When the vehicle is locked, the rear lid auto-
matically unlocks on opening if there is a val-
id vehicle key in the proximity zone
›››
Fig. 76.
Open or close the rear lid normally.
After closing, the hatch locks automatically.
If the complete vehicle is unlocked, the rear
lid will not lock automatically after closing it.
What happens when locking the vehicle
with a second key
If there is a vehicle key inside the vehicle and
it is locked from the outside with a second
vehicle key, the key inside the vehicle is
blocked for engine ignition
›››
page 196 . In
order to enable engine ignition, press the
button on the key inside the vehicle.
Automatically disabling sensors
If the vehicle is not locked or unlocked for a
long period of time, the proximity sensors on
96
To Next Page
Loading...
