Cupra Ateca 2020 - Tail Lights Bulbs Located in the Rear Lid

Fuses and bulbs
CAUTION
Take care when removing the rear light unit
to make sure there is no damage to the
paintwork or any of its components.
Note
●
Make sure you have a soft cloth ready to
place under the glass on the rear light unit,
to avoid any scratches.
●
In the case of LED lights, change only the
turn signal bulb.
Tail lights bulbs located in the rear lid
Fig. 51
Rear lid open: remove the cover.
Fig. 52 Remove the bulb holder.
The rear lid must be open to change the
bulbs.
–
Remove the rear lid cover in the direction
indicated
›››
Fig. 51 .
–
Unlock the securing tabs from the bulb
holder
›››
Fig. 52
1
or turn the bulb holder
to the left
2
and
3
.
–
Remove the bulb holder from its location.
–
Lightly press the defective bulb into the
bulb holder, then turn it to the left and re-
move it.
–
Fit the new bulb, pressing it into the bulb
holder and turn it to the right as far as it will
go.
–
Use a cloth to remove any fingerprints
from the glass part of the bulb.
–
Check that the new bulb works properly.
–
Carry out the same actions in reverse order
for assembly and pay special attention to
placing the bulb holder, ensuring that the
tabs are properly secured.
Note
For LED pilots, you can only change the re-
verse bulb.
61