Lights
Fog lights with cornering light func-
tion
The cornering light function is an additional
function to the dipped beam headlights to
improve lighting of the side of the road when
taking a sharp turn at low speed.
The cornering light function works when the
dipped beam headlights are already on and it
is activated when driving at speeds below ap-
proximately 40 km/h (25 mph).
●
If the steering wheel is turned or the turn
signal is switched on, the front fog light grad-
ually turns on. After the turn, the cornering
light function is gradually switched off.
●
When engaging reverse gear, both front
fog lights turn on.
“Coming home” and “Leaving home”
function
The “Coming home” and “Leaving home”
function lights up the vehicle’s immediate
proximity when getting into and out of it in
the dark. When switched on, the front posi-
tion and dipped beam lights, tail lights and li-
cense plate light come on.
The “Leaving Home” is controlled by a pho-
tosensor.
In the vehicle settings menu of the infotain-
ment system you can adjust the duration of
the light switch-off delay, and activate and
deactivate the function.
Activating the “Coming Home” function
For vehicles with light and rain sensors.
●
Switch off the engine and remove the key
from the ignition with the light switch in posi-
tion
›››
page 112 .
●
The automatic “Coming Home” function is
only active when the light sensor detects
darkness.
For vehicles without light and rain sensors.
●
Switch the ignition off.
●
Activate the headlight flashers for approxi-
mately 1 second.
When the driver door is opened, the “Com-
ing Home” lighting comes on. The headlight
turning off time counts from when the last
door or rear lid are closed.
The “Coming Home” lighting turns off in
the following cases:
●
Automatically, once the headlight turning
off time has elapsed.
●
Automatically, when a vehicle door or the
rear lid is still open 30 seconds after starting
the engine.
●
When the rotary light switch is turned to
position
›››
page 112 .
●
With the ignition is switched on.
Activating the “Leaving Home” function
●
Unlock the vehicle using the remote con-
trol.
●
The “Leaving Home” function is only acti-
vated when the light switch is in position
and the light sensor detects darkness.
The “Leaving Home” lighting switches off
in the following cases:
●
Automatically, when the “Leaving Home”
switch-on time ends (default 30 sec).
●
When the vehicle is locked using the re-
mote control.
●
When the light switch is turned to position
.
●
With the ignition is switched on.
Welcome light
The welcome light is a light located on the
exterior mirrors, focused on the ground,
which activates or deactivates if the light
switch is in the
position and the “Coming
Home” or “Leaving Home” function is turned
on or off.
»
117
To Next Page
