Driving
A wake will indicate the anticipated forward
or backward trajectory, depending on the
engaged gear.
If an obstacle is located in the vehicle’s way,
the corresponding audible warning will
sound.
When the penultimate segment is displayed,
the vehicle has reached the collision zone. In
the collision zone, the obstacles are repre-
sented in red (including those out of the
path). Stop the vehicle!
›››
in Introduction
on page 258,
›››
in Introduction on
page 259 !
In the event the car is equipped with the Top
View Camera system, Park Assist visual guid-
ance will appear in accordance with the view
selected in the Top View Camera system.
Setting the indications and audio sig-
nals
The displays and audio signal settings are set
in the infotainment system
›››
page 84 .
Setup
Automatic activa-
tion
On/off
Front volume*
Volume in the front and rear
area.
Rear volume* Volume in the rear area.
Setup
Adjust volume
When the parking aid is
switched on, the volume of
the audio source will be re-
duced, depending on the se-
lected option.
Front sound set-
tings/sharpness*
Sound tone in the front area.
Rear sound set-
tings/sharpness*
Sound tone in the rear area.
Error messages
If a an error or fault message appears on the
instrument cluster in Park Assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
next time the parking aid is connected.
If a rear sensor is faulty, only the obstacles in
area
A
are displayed
›››
Fig. 183 . If a front
sensor is faulty, only the obstacles in area
B
are displayed. Symbol
is displayed.
We recommend taking the vehicle to a spe-
cialised workshop to have the fault repaired.
Trailer mode
Fig. 186
Parking assist display on the screen with
trailer attached.
On vehicles with a factory-fitted trailer hitch,
when the trailer is connected, the rear sen-
sors will not activate when reverse gear is en-
gaged or button
is pressed. Therefore,
any objects behind or to the side of the vehi-
cle will not be indicated on the screen and
no audio signals will sound.
The screen will only display objects detected
at the front, and the vehicle's trajectory will
be hidden.
Manoeuvre braking function*
The emergency braking function is used to
minimise damage in the event of a collision.
Depending on the equipment, if the Parking
Aid is active, the braking while manoeuvring
262
To Next Page
Loading...
