Operation
●
Press the button on the multi-function
steering wheel to memorise the current
speed and activate the warning.
●
Activate: set the desired speed within 5
seconds by rotating the wheel on the multi-
function steering wheel. Next, press the
button again or wait several seconds. The
speed is stored and the warning activated.
●
Deactivate: press the
button. The stor-
ed speed is deleted.
The warning can be adjusted for speeds be-
tween 30 km/h (18 mph) and 250 km/h
(155 mph).
Display
Oil temperature
The engine reaches its operating tempera-
ture when, under normal driving conditions,
the oil temperature is between 80°C (176°F)
and 120°C (248°F). If a great effort is required
from the engine and the outside tempera-
ture is high, the engine oil temperature may
increase. This does not present any problem
as long as the warning lamps
or
›››
page 291 do not appear on the display.
Warning and information messages
(Vehicle status)
The system runs a check on certain compo-
nents and functions when the ignition is
switched on and while the vehicle is moving.
Faults are displayed on the instrument clus-
ter display as red and yellow warning symbols
accompanied with messages and, as appli-
cable, even an audible signal
›››
page 81 .
The representation of the messages and
symbols may vary depending on the version
of the instrument panel.
Existing faults can also be checked manually.
To do so, open the menu
Vehicle status
or
Vehicle
›››
page 70 .
Priority 1 warning (red)
The symbol lights up or flashes (in part ac-
companied by audible warnings).
Stop
driving! Danger! Check the fault and elimi-
nate the cause. If necessary, seek professio-
nal assistance.
Priority 2 warning (yellow)
The symbol lights up or flashes (in part ac-
companied by audible warnings). Operating
faults or the lack of operating fluids can
cause damage to the vehicle or a fault.
Check the faulty function as soon as possi-
ble. If necessary, seek professional assis-
tance.
Information message
It provides information about processes in
the vehicle.
Driver alert system (break recommen-
dation)*
Fig. 58
On the instrument panel display: driver
alert system symbol.
The Fatigue detection informs the driver
when their driving behaviour shows signs of
fatigue.
Function and operation
Fatigue detection determines the driving be-
haviour of the driver when starting a journey,
making a calculation of tiredness. This is
constantly compared with the current driv-
ing behaviour. If the system detects that the
driver is tired, an audible warning is given
with a sound and an optic warning is shown
with a symbol and complementary message
on the instrument panel display
›››
Fig. 58 .
The message on the instrument panel dis-
play is shown for approximately 5 seconds,
72
To Next Page
Loading...
