Currie tech IZIP - Page 34

34
 
Afterpressing‘Power’,alleightmeterlightswillashin
sequence, indicating that the bike is ready to ride.
Ifyourbikehasanadditionalphysicalswitchorbattery
selector located behind or in front of the batteries, be sure
itisturnedtotheproperpositionbeforepressing‘Power’.
 

Thebatterygaugeprovidesfiveindicationsofbattery
level.
When the battery is depleted to the point of automatic
shutoff, the lowest gauge light will blink indicating the
needtorechargeimmediately.Ofcourse,thebicyclecan
still be ridden with the system turned off.
Duetothewaythebatterygaugemeasurescharge,the
indicatorlightsmayuctuatewhileridingbasedonthe
motor’s current load.
The best indication of remaining battery life is to check the
batterylevelgaugeLEDsafterreachingcruisingspeed
onasmooth,at,straightroad.Thiswillallowthebattery
voltage to stabilize and will give a much more accurate
reading.
   

ThePASsystemprovidesthreeassistlevels,whichcan
becycledbetweenusingthe‘Assist+/-’button.
Each level of assist corresponds to a maximum motor
speed;atlevel3,themotorrunsatfullpower.Overall
range decreases at higher power levels.
The system defaults to the lowest assist level at startup.
The motor will activate when the system senses the rider
pedaling.Itisnotpossibletoactivatethemotorwithout
turning the cranks.