Currie tech IZIP - Page 35

35
 
Do not put any pressure on the pedals when turning the
bicycle on.DoingsomayaffecttheTMMsensorcalibra-
tion(theTMMsensorisre-calibratedeachandeverytime
the power is turned on).
Ifyourbikehasanadditionalphysicalswitchorbattery
selector located behind or in front of the batteries, be sure
itisturnedtotheproperpositionbeforepressing‘Power’.
Afterpressing‘ON/OFF’,alltenmeterlightswillashin
sequence, indicating that the bike is ready to ride.
Toturnthebicycleoff,holdthe'ON/OFF'buttonforabout
3seconds.
 

Thebatterygaugeprovidesfiveindicationsofbattery
level.
When the battery is depleted to the point of automatic
shutoff, the lowest gauge light will blink indicating the
needtorechargeimmediately.Ofcourse,thebicyclecan
still be ridden with the system turned off.
Duetothewaythebatterygaugemeasurescharge,the
indicatorlightsmayuctuatewhileridingbasedonthe
motor’s current load.
The best indication of remaining battery life is to check the
batterylevelgaugeLEDsafterreachingcruisingspeed
onasmooth,at,straightroad.Thiswillallowthebattery
voltage to stabilize and will give a much more accurate
reading.
  

TheTMMsystemprovidesfiveassistlevels,whichcan
becycledbetweenusingthe'+’and'-'buttons.
Each increasing level of assist gives more motor power,
but also decreases overall range.
Thesystemdefaultstoassistlevel3atstartup.
The motor will activate when the system senses the
riderapplyingpressuretothepedals.Itisnotpossibleto
activate the motor without rider input.
Torque Measurement
Method