Cygnus DIVE Operating Manual M2-DIVE-M-ENG_Iss5.docx
Page 33 of 118
9. Using the DIVE Gauge
Turning the Gauge On
Fitting a battery to the DIVE gauge will
turn on the gauge.
The gauge will display the Cygnus logo
screen while it starts up.
If the DIVE gauge has gone into standby
mode then press and hold either button
until the gauge turns on (this may take up
to 5 seconds).
Note. Turning the gauge back on from
standby will skip the following two steps.
The next screen displays the Serial
Number, Software Version and Run Time.
You can freeze the screen by pressing any
button, press again to unfreeze and
continue.
Your attention is drawn to the warranty
statement.
The next screen displays a red warning
message reminding you to remove the
battery after use and to re-calibrate before
use.
Press either button to continue.
To Next Page
Loading...
Need help?
General