Cygnus M2-DIVE - Connecting to the Gauge Afterwards; Disconnecting from the Gauge; Manual Connection Settings

Cygnus DIVE Operating Manual M2-DIVE-M-ENG_Iss5.docx
Page 86 of 118
Connecting to the Gauge Afterwards
1.
Once you have discovered
the
Gauge the connection settings
will be stored for next time, so
to connect next time simply click
from the menu;
Connect
└ Connect to M2-DIVE Gauge
Disconnecting from the Gauge
1.
To disconnect from the Gauge
simply click from the menu;
Connect
└ Disconnect from Gauge
Manual Connection Settings
If you need to manually set the connection settings then select the
Connection Settings option from the Connect menu, here you
can specify the COM Port number, gauge type and baud rate.