D-Link DXS-3400 SERIES - VLAN Mapping Profile

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
132
Parameter Description
Original Inner VID
Enter the original inner VLAN’s ID here. The range is from 1 to 4094.
Action
Select the action that will be taken here. Options to choose from are Translate
and Dot1q-tunnel.
• Translate - Specifies that the outer-VID will replace the outer-VID of the
matched packets.
• Dot1q-tunnel - Specifies that the outer-VID will be added for matched
packets.
VID
Enter the VLAN’s ID here. The range is from 1 to 4094.
Inner VID
Enter the inner VLAN’s ID here. The range is from 1 to 4094.
Priority
Select the 802.1p priority value here. The range is from 0 to 7. A lower value has
a higher priority.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
VLAN Mapping Profile
This window is used to display and configure the VLAN mapping profile settings.
To view the following window, click L2 Features > VLAN Tunnel > VLAN Mapping Profile, as shown below:
Figure 5-43 VLAN Mapping Profile Window
The fields that can be configured are described below:
Parameter Description
Profile ID
Enter the ID of the VLAN mapping profile here. A lower ID has a higher priority.
The ID range is from 1 to 1000.
Type
Select the profile type here. Different profiles can match different fields. Options to
choose from are Ethernet, IP, IPv6, and Ethernet-IP.
• Ethernet - The profile can match Layer 2 fields.
• IP - The profile can match Layer 3 IP fields.