DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
205
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Static/Default Route
This window is used to display and configure the IPv6 static or default routes.
To view the following window, click L3 Features > IPv6 Static/Default Route, as shown below:
Figure 6-23 IPv6 Static/Default Route Window
The fields that can be configured are described below:
Parameter Description
IPv6 Address/Prefix Length
Enter the IPv6 address and prefix length for this route here. Tick the Default
Route option to use this route as the default route.
Interface Name
Enter the name of the interface that will be associated with this route here.
Next Hop IPv6 Address
Enter the next hop IPv6 address here.
Distance
Enter the administrative distance of the static route here. This value must be
between 1 and 254. A lower value represents a better route. If not specified, the
default administrative distance for a static route is 1.
Backup State
Select the backup state option here. Options to choose from are Primary, and
Backup. When the Primary option is selected, the route is specified as the
primary route to the destination. When the Backup option is selected, the route is
specified as the backup route to the destination.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Static Route BFD
This window is used to display and configure the IPv6 static route BFD.
To view the following window, click L3 Features > IPv6 Static Route BFD, as shown below:
To Next Page
Loading...
