DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
222
Policy Route
This window is used to display and configure the policy route settings.
To view the following window, click L3 Features > Policy Route, as shown below:
Figure 6-45 Policy Route Window
Click the Edit button to modify the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Edit button, the following page will appear.
Figure 6-46 Policy Route (Edit) Window
The fields that can be configured are described below:
Parameter Description
Route Map
Enter the route map’s name here that will be used in this policy route entry.
Click the Apply button to accept the changes made.
VRRP Settings
This window is used to display and configure the Virtual Router Redundancy Protocol (VRRP) feature’s settings. All
routers in the same VRRP group must be configured with the same virtual router ID and IP address.
A virtual router group is represented by a virtual router ID. The IP address of the virtual router is the default router
configured on hosts. The virtual router’s IP address can be a real address configured on the routers, or an unused IP
address. If the virtual router address is a real IP address, the router that has this IP address is the IP address owner.
A master will be elected in a group of routers that supports the same virtual routers. Others are the backup routers.
The master is responsible for forwarding the packets that are sent to the virtual router.
To view the following window, click L3 Features > VRRP Settings, as shown below:
To Next Page
Loading...
