D-Link DXS-3400 SERIES - RADIUS Server Settings

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
313
Figure 9-29 RADIUS Global Settings Window
The fields that can be configured in RADIUS Global Settings are described below:
Parameter Description
DeadTime
Enter the dead time value here. This value must be between 1 and 1440 minutes.
By default, this value is 0 minutes. When this option is 0, the unresponsive server
will not be marked as dead. This setting can be used to improve the
authentication processing time by setting the dead time to skip the unresponsive
server host entries.
When the system performs authentication with the authentication server, it
attempts one server at a time. If the attempted server does not respond, the
system will attempt the next server. When the system finds a server does not
respond, it will mark the server as down, start a dead time timer, and skip them in
authentication of the following requests until expiration of the dead time.
Click the Apply button to accept the changes made.
The fields that can be configured in RADIUS Global IPv4 Source Interface are described below:
Parameter Description
IPv4 RADIUS Source
Interface Name
Enter the name of the source IPv4 RADIUS interface here.
Click the Apply button to accept the changes made.
The fields that can be configured in RADIUS Global IPv4 Source Interface are described below:
Parameter Description
IPv6 RADIUS Source
Interface Name
Enter the name of the source IPv6 RADIUS interface here.
Click the Apply button to accept the changes made.
RADIUS Server Settings
This window is used to display and configure the RADIUS server settings.
To view the following window, click Security > RADIUS > RADIUS Server Settings, as shown below: