DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
296
Parameter Description
Click the Apply button to accept the changes made.
Port Security Address Entries
This window is used to display, clear and configure the port security address entries.
To view the following window, click Security > Port Security > Port Security Address Entries, as shown below:
Figure 9-3 Port Security Address Entries Window
The fields that can be configured are described below:
Parameter Description
Unit
Select the Switch unit that will be used for this configuration here.
Port
Select the appropriate port range used for the configuration here.
MAC Address
Enter the MAC address here. Select the Permanent option to specify that all
learned MAC addresses will not be purged out unless the user manually deletes
those entries.
VID
Enter the VLAN ID here. This value must be between 1 and 4094.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove a new entry based on the information entered.
Click the Clear by Port button to clear the information based on the port selected.
Click the Clear by MAC button to clear the information based on the MAC address entered.
Click the Clear All button to clear all the information in this table.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
802.1X
802.1X (Port-based and Host-based Access Control)
The IEEE 802.1X standard is a security measure for authorizing and authenticating users to gain access to various
wired or wireless devices on a specified Local Area Network by using a Client and Server based access control model.
This is accomplished by using a RADIUS server to authenticate users trying to access a network by relaying
Extensible Authentication Protocol over LAN (EAPOL) packets between the Client and the Server.
The following figure represents a basic EAPOL packet:
To Next Page
Loading...
