D-Link DXS-3400 SERIES - Ripng Interface Settings

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
213
Parameter Description
distance value represents the trust rating of the route. The route with a lower
distance value is preferred over the route with the higher distance value. Select
the Default option to use the default administrative distance for RIPng, which is
120.
Update Time
Enter the update interval value at which the update message is sent here. The
range is from 5 to 65535 seconds. Select the Default option to use the default
value here which is 30 seconds.
Invalid Time
Enter the invalidate timer value in seconds here. The range is from 1 to 65535
seconds. Select the Default option to use the default value here which is 180
seconds.
Flush Time
Enter the flush timer value in seconds here. The range is from 1 to 65535
seconds. Select the Default option to use the default value here which is 120
seconds.
Poison Reverse
Select to enable or disable the poison reverse feature here. When poison reverse
is enabled, the routes learned from an interface will be advertised out to the same
interface with an unreachable metric.
Split Horizon
Select to enable or disable the split horizon feature here. When split horizon is
enabled, the routes learned from an interface will be not advertised out to the
same interface.
Click the Apply button to accept the changes made.
The fields that can be configured in Redistribute Settings are described below:
Parameter Description
Protocol
Select the protocol whose routes are to be redistributed here. Options to choose
from are Connected and Static. The Static option means to redistribute IPv6
static routes. The Connected option refers to routes that are established
automatically by virtue of configuring IPv6 address on an interface.
Metric
Enter the value to be used as the metric for the redistributed routes here. The
range is from 0 to 16. Select the Default option to use the default metric value.
Click the Apply button to accept the changes made.
Click the Delete button to delete an entry based on the information entered.
RIPng Interface Settings
This window is used to display and configure the RIPng feature’s interface settings.
To view the following window, click L3 Features > RIPng > RIPng Interface Settings, as shown below:
Figure 6-33 RIPng Interface Settings Window
The fields that can be configured are described below: