DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
421
Parameter Description
RCP Server IP
Enter the RCP server’s IP address here.
User Name
Enter the user name used for the RCP connection here. This name can be up to
32 characters long.
Source File
Enter the source filename and path of the firmware file located on the RCP server
here. This field can be up to 64 characters long.
Destination File
Enter the destination path and location where the new firmware should be stored
on the Switch. This field can be up to 64 characters long.
Click the Upgrade button to initiate the firmware upgrade.
Firmware Backup to HTTP
This window is used to initiate a firmware backup to a local PC using HTTP.
To view the following window, click Tools > Firmware Upgrade & Backup > Firmware Backup to HTTP, as shown
below:
Figure 13-6 Firmware Backup to HTTP Window
The fields that can be configured are described below:
Parameter Description
Unit
Select the Switch unit that will be used for this configuration here.
Source File
Enter the source filename and path of the firmware file located on the Switch
here. This field can be up to 64 characters long.
Click the Backup button to initiate the firmware backup.
Firmware Backup to TFTP
This window is used to initiate a firmware backup to a TFTP server.
To view the following window, click Tools > Firmware Upgrade & Backup > Firmware Backup to TFTP, as shown
below:
Figure 13-7 Firmware Backup to TFTP Window
The fields that can be configured are described below:
To Next Page
Loading...
