DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
71
The fields that can be configured are described below:
Parameter Description
Name Server IPv4
Select and enter the IPv4 address of the DNS server.
Name Server IPv6
Select and enter the IPv6 address of the DNS server.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
DNS Host Settings
This window is used to display and configure the static mapping entry for the host name and the IP address in the host
table.
To view the following window, click Management > DNS > DNS Host Settings, as shown below:
Figure 4-61 DNS Host Settings Window
The fields that can be configured are described below:
Parameter Description
Host Name
Enter the host name of the equipment.
IP Address
Select and enter the IPv4 address of the equipment.
IPv6 Address
Select and enter the IPv6 address of the equipment.
Click the Apply button to accept the changes made.
Click the Clear All button to clear the information entered in all the fields on this page.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
NTP
NTP Global Settings
This window is used to display and configure the global Network Time Protocol (NTP) settings.
To view the following window, click Management > NTP > NTP Global Settings, as shown below:
To Next Page
Loading...
