D-Link DXS-3400 SERIES - RIP Distribute List; RIP Interface Settings

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
210
Parameter Description
seconds. Select the Default option to use the default value here which is 180
seconds.
Flush Time
Enter the flush timer value in seconds here. The range is from 1 to 65535
seconds. Select the Default option to use the default value here which is 120
seconds.
Default Metric
Enter the default metric value here. The range is from 1 to 16. The default metric
is used in redistributing routes from other routing protocols. The routes being
redistributed are learned by other protocols and have incompatible metric as RIP.
The specifying of the metric allows the metric to be synced. Select the Default
option to use the default metric value, which is 0.
Version
Select the global RIP version that will be used as the default version for all
interfaces here. Options to choose from are v1 (RIPv1) and v2 (RIPv2). Select the
Default option to specify that this feature should use the default configuration. By
default, RIPv1 and RIPv2 packets are received, but only RIPv1 packets are sent.
Distance
Enter the administrative distance for RIP here. The range is from 1 to 255. A
lower value represents a better route. Select the Default option to use the default
administrative distance for RIP, which is 100.
Click the Apply button to accept the changes made.
RIP Distribute List
This window is used to display and configure the RIP distribution list settings.
To view the following window, click L3 Features > RIP > RIP Distribute List, as shown below:
Figure 6-29 RIP Distribute List Window
The fields that can be configured are described below:
Parameter Description
ACL Name
Enter the name of the standard IP access list that will be used here. This name
can be up to 32 characters long.
Interface Name
Enter the name of the interface that will be used here. This name can be up to 12
characters long.
Click the Apply button to accept the changes made.
RIP Interface Settings
This window is used to display and configure the RIP interface’s settings.
To view the following window, click L3 Features > RIP > RIP Interface Settings, as shown below: