D-Link DXS-3400 SERIES - Page 179

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
169
Parameter Description
From Port ~ To Port
Select the appropriate port range used for the configuration here.
Limit Number
Enter the limit number here. This is used to set the limitation on the number of
MLD cache entries that can be created. The range is from 1 to 256.
Exceed Action
Select the exceed action here. This parameter specifies the action for handling
newly learned groups when the limitation is exceeded.
Options to choose from are Default, Drop and Replace.
• Default - Specifies that the default action will be taken.
• Drop - Specifies that the new group will be dropped.
• Replace - Specifies that the new group will replace the oldest group.
Except ACL Name
Enter the standard IP access list’s name here. The group (*,G), or channel (S,G)
permitted by the access list will be excluded from the limit. To permit a channel
(S,G), specify S in the source address field and G in the destination address field
of the access list entry. To permit a group (*,G), specify “any” in the source
address field and G in the destination address field of the access list entry. This
name can be up to 32 characters long. Alternatively, click the Please Select
button to find and select any of the exiting access lists configured on the Switch to
be used in this configuration.
VID
Enter the Layer 2 VLAN’s name on a trunk port here. This applies the filter to
packets that arrive on that VLAN. The range is from 1 to 4094.
Click the Apply button to accept the changes made.
Click the Delete button to delete an entry based on the information entered.
The fields that can be configured in Access Group Settings are described below:
Parameter Description
Unit
Select the Switch unit that will be used for this configuration here.
From Port ~ To Port
Select the appropriate port range used for the configuration here.
Action
Select Add to add a new entry based in the information entered.
Select Delete to delete an entry based in the information entered.
ACL Name
Enter the standard IP access list’s name here. This is used to permit users to join
a group (*, G), specify “any” in source address field and G in destination address
field of the access list entry. This name can be up to 32 characters long.
Alternatively, click the Please Select button to find and select any of the exiting
access lists configured on the Switch to be used in this configuration.
VID
Enter the VLAN’s ID used for this configuration here. The range is from 1 to 4094.
Click the Apply button to accept the changes made.
The fields that can be configured in MLD Snooping Filter Table are described below:
Parameter Description
Unit
Select the Switch’s unit ID that will be used here.
From Port ~ To Port
Select the Switch’s port range that will be used here.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to display all the entries.
Click the Show Detail button to view more detailed information about the entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Show Detail button, the following window will appear.