DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
8
Figure 3-4 Port Settings Window
The fields that can be configured are described below:
Parameter Description
Unit
Select the stacking unit ID of the Switch that will be configured here.
From Port ~ To Port
Select the appropriate port range used for the configuration here.
Medium Selecting
Select the port medium type here. Options to choose from are Auto, RJ45 and
SFP.
Note: Selecting the SFP option, includes the use of SFP+ transceivers for 10G
connectivity.
Medium Type
Select the port medium type here. Options to choose from are RJ45 and SFP.
Note: Selecting the SFP option, includes the use of SFP+ transceivers for 10G
connectivity.
State
Select this option to enable or disabled the physical port here.
MDIX
Select the Medium Dependent Interface Crossover (MDIX) option here. Options to
choose from are Auto, Normal, and Cross.
• Auto - Select this option for auto-sensing of the optimal type of cabling.
• Normal - Select this option for normal cabling. If this option is selected, the
port is in the MDIX mode and can be connected to a PC’s NIC using a
straight-through cable or a port (in the MDI mode) on another switch through
a cross-over cable.
• Cross - Select this option for cross cabling. If this option is selected, the port
To Next Page
Loading...
