D-Link DXS-3400 SERIES - Page 230

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
220
Figure 6-43 Route Map (Match Clauses, Edit) Window
The fields that can be configured are described below:
Parameter Description
Action
Select Add to add a new entry based in the information entered.
Select Delete to delete an entry based in the information entered.
Interface Name
Select and enter the interface’s name that will be used here. This option is used to
define a clause to match the route’s outgoing interface.
IP Address ACL
Select and enter the standard or extended IP access list’s name here. This option
is used to define a clause to match the route based on the standard or extended
IP access list.
IP Next Hop ACL
Select and enter the standard IP access list’s name here. This option is used to
define a clause to match the route’s next hop based on the standard or extended
IP access list.
Route Source
Select and enter the standard or extended IP access list’s name here. This option
is used to define a clause to match the route’s source based on the standard or
extended IP access list.
Metric
Select and enter the metric value of the route here. The range is from 0 to
4294967294. This option is used to define a clause to match the route’s metric.
Route Type
Select the route type here. Options to choose from are Internal, External,
External Type-1, and External Type-2.
• Internal - Specifies the intra-area and inter-area routes of Open Shortest
Path First (OSPF).
• External - Specifies the autonomous system’s external route of OSPF. If the
type-1 and type-2 options are not specified, type-1 and type-2 external routes
are included.
• External Type-1 - Specifies the type-1 external route of OSPF.
• External Type-2 - Specifies the type-2 external route of OSPF.
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
After clicking the Edit button in the Set Clauses column, the following page will appear.