D-Link DXS-3400 SERIES - Page 337

DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
327
Parameter Description
VID List
Enter the VLAN ID list used here.
State
Select to enable or disable the ARP inspection option’s state for the specified
VLAN here.
Click the Apply button to accept the changes made.
ARP Inspection Statistics
This window is used to display and clear the ARP inspection statistics information.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP Inspection
Statistics, as shown below:
Figure 9-49 ARP Inspection Statistics Window
The fields that can be configured are described below:
Parameter Description
VID List
Enter the VLAN ID list used here.
Click the Clear by VLAN button to clear the information based on the VLAN ID(s) entered.
Click the Clear All button to clear all the information in this table.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
ARP Inspection Log
This window is used to display, configure and clear the ARP inspection log information.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP Inspection Log, as
shown below:
Figure 9-50 ARP Inspection Log Window
The fields that can be configured are described below:
Parameter Description
Log Buffer
Enter the log’s buffer value used here. This value must be between 1 and 1024.
By default, this value is 32.
Click the Apply button to accept the changes made.