DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
333
IPv6 ND Inspection
This window is used to display and configure the IPv6 ND inspection settings.
To view the following window, click Security > IMPB > IPv6 > IPv6 ND Inspection, as shown below:
Figure 9-57 IPv6 ND Inspection Window
The fields that can be configured are described below:
Parameter Description
Policy Name
Enter the policy name used here. This name can be up to 32 characters long.
Device Role
Select the device role here. Options to choose from are Host and Router. By
default, the device’s role is set as host and inspection for NS and NA messages
are performed. If the device role is set as router, the NS and NA inspection is not
performed. When performing NS/NA inspection, the message will be verified
against the dynamic binding table learned from the ND protocol or from the
DHCP.
Validate Source-MAC
Select to enable or disable the validation of the source MAC address option here.
When the Switch receives an ND message that contains a link-layer address, the
source MAC address is checked against the link-layer address. The packet will be
dropped if the link-layer address and the MAC addresses are different from each
other.
Target Port
Tick this option to specify the target port.
Unit
Select the Switch unit that will be used for this configuration here.
From Port ~ To Port
Select the appropriate port range used for the configuration here.
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specified entry.
IPv6 RA Guard
This window is used to display and configure the IPv6 Router Advertisement (RA) guard settings.
To view the following window, click Security > IMPB > IPv6 > IPv6 RA Guard, as shown below:
To Next Page
Loading...
