DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
375
Figure 10-7 CFM Settings (Add MA, Add MEP, MEPID Detail, Edit) Window
The fields that can be configured are described below:
Parameter Description
MEP State
Select to enable or disable the MEP’s state on the interface here.
CCM State
Select to enable or disable the CCM feature’s state here.
PDU Priority
Select the PDU priority value here. The range is from 0 to 7. This feature is used
to define the 802.1p priority that is set in the CCM and the LTM messages
transmitted by the MEP.
Fault Alarm
Select the type of defects whose fault alarms can be sent by this MEP. Options to
choose from are None, All, MAC-Status, Remote-CCM, Error-CCM, and XCON-
CCM.
• None - Specifies that no fault alarm will be sent.
• All - Specifies that the fault alarms for all types of defects can be sent.
• MAC-Status - Specifies that the fault alarms for the defects whose priority is
equal to or higher than the DefMACstatus can be sent.
• Remote-CCM - Specifies that the fault alarms for the defects whose priority
is equal to or higher than the DefRemoteCCM can be sent.
• Error-CCM - Specifies that the fault alarms for the defects whose priority is
equal to or higher than the DefErrorCCM can be sent.
• XCON-CCM - Specifies that only the fault alarm of the DefXconCCM can be
To Next Page
Loading...
