D-Link xStack DES-3528 Series - Page 572

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
572
DES-3528:admin#config power_saving hibernation delete time_range range_2
Command: config power_saving hibernation delete time_range range_2
Success.
DES-3528:admin#
config power_saving led
Purpose
This command is used to add or delete the power saving schedule on the LED of all ports.
Syntax config power_saving led [[add | delete] time_range <range_name 32> |
clear_time_range]
Description
When any schedule is up, all port’s LED will be turned off even device’s LED working on PoE
mode.
Parameters add - Specifies to add a time range here.
delete - Specifies to delete a time range here.
time_range - Specifies the name of the time range used.
<range_name 32> - Enter the name of the time range used here. This name can be up to 32
characters long.
clear_time_range - Specifies to clear all the time ranges of system hibernation.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To add a time range named “range_1” on port LED:
DES-3528:admin#config power_saving led add time_range range_1
Command: config power_saving led add time_range range_1
Success.
DES-3528:admin#
To delete a time range named “range_2” on LED: