Local Basic Operation 144
Before you control the PTZ, make sure the PTZ decoder and the NVR network connection is
OK.
4.4.1 PTZ Settings
You can set different PTZ parameters for local type and remote type. Before you use local PTZ,
make sure you have set PTZ protocol; otherwise you cannot control the local PTZ.
Local: The PTZ device connects to the NVR via the cable.
Remote: The PTZ device connects to the NVR via the network.
This function is for some series products only.
Step 1 Select Main menu > CAMERA > PTZ.
Step1 The PTZ interface is displayed. See Figure 4-82 (Local) or Figure 4-83 (Remote).
Figure 4-82
To Next Page
Loading...
