Local Basic Operation 260
Figure 4-193
Step 2 In the Destination IP box, enter the IP address.
Step 3 Click Test.
After testing is completed, the test result is displayed. You can check the evaluation for average
delay, packet loss, and network status.
4.10.4 Maintenance and Management
4.10.4.1 Device Maintenance
When the Device has been running for a long time, you can configure the auto reboot when the
Device is not working. You can also configure the case fan mode to reduce noise and extend the
service life.
Step 1 Select Main Menu > OPERATION > SYSTEM MAINTAIN > AUTO MAINTAIN.
The AUTO MAINTAIN interface is displayed. See Figure 4-194.
.
To Next Page
Loading...
Need help?
General
