Dahua ESS2016X - Ess5016 D-R; Front Panel

ESS Series User’s Manual
7
Figure 1-10
You can refer to the following sheet for detailed information.
SN
Port
Function
1
Power Port
Connect to AC power supplying.
2
Case fan
It is for case ventilation.
3
Power fan
It is for power ventilation
4
Main control module
It is about all kinds of ports and indictor light
introduction. Please refer to the following sheet.
5
Case fan
It is for case ventilation.
6
Battery box
Reserved
You can refer to the following sheet for master control module information.
SN
Function
LAN1～LAN4
1000Mbps data Ethernet port. It is to transmit data.
10G_1, 10G_2
10000Mbps data Ethernet port. It is to transmit data. (Optional)
WEB port
Ethernet Management port. Login Web via this port.
USB port
USB port
PORT1/PORT2
Connect to the IN port of the disk array enclosure.
CONSOLE
COM port. It is to debug the device and view the login command interface.
RUN
The light is on after system booted up and begins running.
M/S
Main control indictor light.
The light is on when system is malfunction.
The light is off when system is running properly.
ERR
System error indictor light.
 The error light is on when system is abnormal.
 The error light is off when system is running properly.
CACHE
It is reserved for future use.
RST
Press it for 5 seconds to restore default setup (network setup, user password,
time sync, email alarm and etc.).
1.6 ESS5016D-R
1.6.1 Front Panel
The front panel is shown as in Figure 1-11.