ESS Series User’s Manual
After you install the HDD, you need to install the front panel on the device. It is to reduce the risk
of HDD stealing or mistakenly remove operation.
a) Put the front panel to face you and make sure all lock holes are matching. Slowly push
the front panel to the device.
b) After confirm the front panel installation is right, use the key to secure the locker on both
sides of the front panel.
2.4 Battery Installation
Note
This is for dual-control host series only.
Please follow the steps listed below to install the battery. See Figure 2-2 (16-HDD series) and
Figure 2-3 (24-HDD series).
a) Take the battery&fan box from the device and then use the screwdriver to remove the top
cover of the battery box.
b) Take out the battery from the accessories’ bag and then insert to the battery box. Connect
the battery to the power socket.
c) Fix the top cover of the battery box and then secure the screws.
d) Insert the battery box to the device and then secure firmly.
Figure 2-2
To Next Page
Loading...