ESS Series User’s Manual
Figure 2-3
2.5 Boot up
Please boot up he disk array enclosure first if the host is connected to the disk array enclosure.
c) Connect the power cable to the system.
d) Press the device power on-off button at the rear panel to ON to boot up the system
(Please skip this step if there is no on-off button at the rear panel).
e) Press the power button at the front panel of the host.
2.6 Shut Down
Please shut down the host first if the host is connected to the disk array enclosure.
a) Login web interface. Please refer to chapter 3.1.
b) From System Management -> Shutdown.
c) Select option to shut down the system.
There are three options for you: shut down/restart/Force restart (For dual-controller series
product only). See Figure 2-4.
Or you can see these two shortcut buttons at the top right corner.
For the dual-controller series product, there are two controllers. Click the restart button; the two
controllers reboot one after the other. Click the force restart button, the two controllers reboot at
the same time.
To Next Page
Loading...
General