SiEBE18-526 Instruction
System Configuration 167
C
TEMP
ON/OFF
POWERFUL
HOME LEAVE
MODE
TIMER
FA N
SWING
SILENT
SENSOR
ON
CANCEL
OFF
1, 3
2
To set the clock
1. Press “CLOCK button”.
is displayed.
blinks.
2. Press “TIMER setting button” to
set the clock to the present time.
3. Press “CLOCK button”.
blinks.
Holding down “ ” or “”button rapidly
increases or decreases the time display.
Turn the breaker ON
Turning ON the breaker opens the flap, then
closes it again. (This isa normal procedure.)
NOTE
Tips for saving energy
• Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate level helpssave energy.
• Cover windows with ablind or a curtain.
Blocking sunlight and air from outdoors increases the cooling (heating) effect.
• Clogged air filters cause inefficient operation and waste energy. Clean them
once in about every two weeks.
Please note
• The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
• If youare not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker OFF.
• Use the air conditioner in the following conditions.
Operation outside this humidity or temperature range may cause asafety device to disable the system.
Recommended temperature setting
For cooling: 26
°
C – 28
°
C
For heating: 20
°
C – 24
°
C
Mode
COOL
HEAT
DRY
Operating conditions If operation is continued out of this range
Outdoor temperature: 2MK(X)S 10 to 46 °C
3/4MK(X)S –10 to 46 °C
RK(X)S –10 to 46 °C
RK(X)H 10 to 46 °C
Indoor temperature: 18 to 32 °C
Indoor humidity: 80% max.
Outdoor temperature: 2MXS –10 to 21 °C
3/4MXS –15 to 21 °C
RXS –15 to 21 °C
RXH –10 to 21 °C
Indoor temperature: 10 to 30 °C
Outdoor temperat
ure:
2MK(X)S 10 to 46 °C
3/4MK(X)S –10 to 46 °C
RK(X)S –10 to 46 °C
RK(X)H 10 to 46 °C
Indoor temperature: 18 to 32 °C
Indoor humidity: 80% max.
• A safety device may work to stop the operation.
(In multi system, it may work to stop the operation of the
outdoor unit only.)
• Condensation may occur on the indoor unit and drip.
• A safety device may work to stop the operation.
• A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and drip.
To Next Page
Loading...
Need help?
General