SiEBE18-526 Instruction
System Configuration 179
Air flow selection
•
Make air flow selection according to what suits you.
•
Air conditioner automatically decides the appropriate blowing pattern depending on the operating
mode/situation.
When setting the air flow selection switch to .
Operating mode Situation Blowing pattern
COOL mode
HEAT mode
•
When the room has become fully
cool, or when one hour has passed
since turning on the air conditioner.
•
At start of operation or other times
when the room is not fully cooled.
•
At times other than below.
(Normal time.)
•
At start or when air temperature is
low.
•
So that air does not come into direct
contact with people, air isblown
upper air outlet, room temperature is
equlised.
•
Air isblown from the upper and lower
air outlets for high speed cooling
during COOL mode, and for filling
the room with warm air dur i n g H EAT
mode.
•
So that air does not come into direct
contact with people. Air isblown
upper air outlet.
•
During Dry mode, so that cold air does not come into direct contact with people, air isblown upper air outlet.
When setting the air outlet selection switch to .
•
Regardless of the operating mode or situation, air blows from the upper air outlet.
• Use thisswitch when you do not want air coming out of the lower air outlet. (While sleeping etc.)
CAUTION
•
Do not try to adjust the flap by hand.
•
When adjusting by hand, the mechanism may not operate properly or condensation may drip from
air outlets.
To Next Page
Loading...
