Instruction SiEBE18-526
184 System Configuration
What’s the HOME LEAVE operation
Useful in these cases.
Is there aset temperature and air flow rate which is most comfortable, aset temperature and air flow rate
which youuse the most? HOME LEAVE operation isa function that allows you to record your favorite set
temperature and air flow rate. You can start your favorite operation mode simply by pressing the HOME
LEAVE button on the remote control. This function is convenient in the following situa
tions.
1. Use as an energy-saving mode
Set the temperature 2-3°C higher (cooling) or lower (heating) than normal. Setting the fan strength to the lowest
setting allows the unit to be used in energy-saving mode. Also convenient for use while youare out or sleeping.
• Every day before you leave the house...
When you go out, push the “HOME LEAVE
Operation”button, and the air conditioner
will adjust capacity to reach the preset
temperature for HOME LEAVE Operation.
• Before bed...
Set the unit to HOME LEAVE
Operation before leaving the
living room when going to bed.
When you return, you will be
welcomed by a comfortably air
conditioned room.
The unit will maintain the
temperature in the room at a
comfortable level while yousleep.
Push the “HOME LEAVE Operation”
button again, and the air conditioner
will adjust capacity to the set
temperature for normal operation.
When you enter the living room in the
morning, the temperature will be just right.
Disengaging HOME LEAVE Operation
will return the temperature to that set
for normal operation. Even the coldest
winters will pose no problem!
2. Use as a favorite mode
Once you record the temperature and air flow rate settings you most often use, you can retrieve them by
pressing HOME LEAVE button. You do not have to go through troublesome remote control operations.
NOTE
• Once the temperature and air flow rate for HOME LEAVE operation are set, those settings will be
used whenever HOME LEAVE operation isused in the future. To change these settings, please refer
to the “Before using HOME LEAVE operation”section above.
• HOME LEAVE operation is only available in COOL and HEAT mode. Cannot be used in AUTO, DRY,
and FAN mode.
• HOME LEAVE operation runs in accordance with the previous operation mode (COOL or HEAT)
before using HOME LEAVE operation.
• HOME LEAVE operation
and POWERFUL operation cannot be used at the same time.
Last button that was pressed has priority.
• The operation mode cannot be changed while HOME LEAVE operation isbeing used.
• When operation isshut off during HOME LEAVE operation, using the remote control or the indoor
unit ON/OFF switch, “” will remain on the remote control display.
To Next Page
Loading...
Need help?
General