Daktronics OMNISPORT 2000 - Introduction to OmniSport 2000 Timing Console; Important Safeguards; Specifications Label

Introduction
1
1 Introduction
This manual explains the operation, installation, maintenance, and troubleshooting of the
OmniSport
®
2000 series timing console Version 16.02.23 and beyond. (Version numbers
refer to the date the version was released; 16.02.23 was released on February 23, 2016.)
For additional information regarding the safety, installation, operation, or service of this
system, refer to the telephone numbers listed in Daktronics Exchange and Repair & Return
Programs (p.3).
Important Safeguards
• Read and understand all instructions, both general and for specic sports.
• Always turn off and/or unplug the control equipment when it is not in use� Never yank
the power cord to pull the plug from the outlet� Grasp the plug and pull to disconnect�
• Do not drop the control console or allow it to get wet�
• This device shall not be exposed to dripping or splashing, and no objects lled with
liquid shall be placed upon it�
WARNING! To reduce the risk of re or electric shock, do not expose this device to
rain or moisture�
• An internal battery backup allows the timer to continue operation for approximately
10 minutes in the event of a power failure�
CAUTION! DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED�
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE.
WARNING! Do not expose batteries to excessive heat, such as direct sunlight or re.
• Do not let the power cord touch hot surfaces or hang over the edge of a table that
would damage or cut the cord�
• If an extension cord is necessary, use a three-pronged, polarized cord� Arrange the
cord with care so that it will not be tripped over or pulled out�
• Before using an extension cord, inspect the cable thoroughly and verify its
compliance with the local electric codes�
• Do not disassemble control equipment or electronic controls of the display; failure to
follow this safeguard will make the warranty null and void�
• Inspect console for shipping damage such as rattles and dents, and verify that all
equipment is included as itemized on the packing slip� Immediately report any
problems to Daktronics; save all packing materials if exchange is necessary�
As a safety feature, this product has a three-wire, ground-type plug equipped with a
third (grounding) pin. This plug only ts into a grounding-type power outlet. If unable to
insert the plug into the outlet, contact a qualied electrician to replace the obsolete
outlet.
Specications Label
Power specications as well as product assembly information can be found on the rear
of the console.
When calling Daktronics customer service, please have the assembly number and the
date manufactured available to ensure the request is serviced as quickly as possible.