Daktronics OMNISPORT 2000 - On-deck System

Timing System Setup
6
On-deck System
Figure 4 illustrates a typical on-deck swimming installation.
The on-deck system uses lane modules
to interconnect the touchpads and
backup buttons to the timing consoles.
Lane modules are universal and can be
used on any lane. The console knows
which module it is by where it is
connected in the chain. Each lane
module (Figure 5) controls one
touchpad and up to three button inputs.
The lane modules daisy chain together,
allowing another module to be plugged
into the end to add another lane
(Figure 6).
Easy servicing is an additional benet
of on-deck cabling. If one lane goes
bad, the whole harness does not have
to be replaced; only that individual lane
module needs replacing. Simply remove
and replace with another Daktronics
lane module.
OMNISPORT CONSOLEEXTENSION MODULE
LANE
MODULE x6
TOUCHPAD x6
PUSH
BUTTONS x6
UP TO 3 PER LANE
HS-200
LANE
SPEAKER x6
AUX
SPEAKER
RELAY TAKE-OFF
PLATFORM x6
Figure 4: On-deck Swimming Installation
Figure 5: Daktronics Lane Module
Figure 6: Daisy Chain Lane Modules